Preparation before configuration: Power on the camera, press and hold the reset button for a few seconds, and then hear the camera voice prompts "Reset completed". When the voice prompts "Please scan the QR code on the camera and wait for connection" and the prompt tone "Didi..." is emitted, it means that the device is waiting for configuration Connection steps: 1. Open the WiFi list of the mobile phone, connect to the device hotspot (XVV+ID), and the "Connected" status under the hotspot means the connection is successful 2. Open the APP, press and hold the drop-down in the blank of the device list to refresh the list 3. The device card appears in the device list, and the device is successfully added 4. Click the play button on the screen, follow the system prompts to set the password, after that, you can do further operations on the device Note: 1. To connect the device in the AP hotspot mode, the mobile phone must remain connected to the device hotspot. Please ensure that the mobile phone is within the hotspot connection range to avoid disconnecting the device 2. Device hotspot means that the signal from the camera cannot connect to the Internet, and other networked applications cannot be used when the phone is connected to the hotspot. Please pay attention